With the ignition switch turned to the “ON” position, this device reminds the driver and front passenger to fasten their seatbelts by illuminating the warning lights in the locations indicated in the following illustration and sounding a chime. To release the Auto Vehicle Hold function When the power steering warning light is illuminated, there may be more resistance when the steering wheel is operated. It remains illuminated in RED for more than 2 seconds. Lynnes Subaru is proud to provide a dashboard light guide for the Subaru Legacy for our Bloomfield, Clifton, and Montclair customers. For more information, visit Subaru.com to learn all … This light shows that the headlights are in the high beam mode. Immediately after the driver’s door is opened or closed when all of the following conditions are met: For models without “keyless access with push-button start system”: Approximately 60 seconds after the ignition switch is turned from the “ON” position to the “ACC” or “LOCK” position. This sequence will continue upon subsequent vehicle start-ups as long as the malfunction exists. It will turn off when the X-mode is deactivated. Accordingly, when the low tire pressure telltale illuminates, you should stop and check your tires as soon as possible, and inflate them to the proper pressure. Have your vehicle checked at a SUBARU dealer immediately. This light illuminates when the brake fluid level has dropped to near the “MIN” level of the brake fluid reservoir with the ignition switch in the “ON” position and with the parking brake fully released. All three at the same time but the Cruise Control keeps blinking on and off. The EBD system may be malfunctioning if the brake system warning light and ABS warning light illuminate simultaneously during driving. The open door is indicated by the corresponding part of the door open indicator. It may take several driving trips. 2011 subaru legacy dashboard warning lights on due to transmission failure 3 Answers. This indicator light illuminates under the following conditions: This light illuminates when the high beam assist function is activated. Asked by GuruYV8P Dec 11, 2018 at 07:48 PM about the 2014 Subaru Forester 2.5i Touring. The push-button ignition switch is in the “ON” or “ACC” position. If you have recently refueled your vehicle, the cause of the CHECK ENGINE warning light/malfunction indicator light illuminating could be a loose or missing fuel filler cap. 2017 Subaru Forester Xt Eyesight Warning Lights Us Spec You If this occurs, immediately stop the vehicle at the nearest safe place and check the brake fluid level. When driving only using the electric motor power, When the engine is automatically stopped by the hybrid system. Email. The warning light illuminates when the engine has stalled and continues to illuminate after the engine has been restarted. The light may remain illuminated for a short period of time after the engine has been started, especially in cold weather. The front passenger’s occupant detection system monitors whether or not there is a passenger on the front passenger’s seat. Use our handy guide to learn more about the various warning lights. Here are the precautions we're taking to keep our guests, staff, and community safe. Ever look down at your Subaru dashboard and see a warning light that looks like a red car with a lock illuminated? Have your vehicle towed to the nearest SUBARU dealer for repair. These lights show the operation of the turn signal or lane change signal. If the brake fluid level is below the “MIN” mark, DO NOT drive the vehicle. Under any of the following conditions, the Auto Vehicle Hold function will be automatically released and the electronic parking brake will be automatically applied. However, this is not a malfunction if the indicator light/warning light turns off after a short time. Then the electronic parking brake indicator light will flash. 2017 subaru forester xt eyesight light on my subaru dashboard mean light on my subaru dashboard mean light on my subaru dashboard mean. Contact your SUBARU dealer immediately for an inspection. If at all in doubt about whether the brakes are operating properly, do not drive the vehicle. However, the conventional brake system continues to operate normally. You disconnect the negative terminal on the battery, turn the key on three times, reconnect the battery and the warning lights will be reset. This BLUE illuminated light turns off when the engine is warmed up sufficiently. The dash lights typically return to normal after several ignition cycles and after driving for several hours. Even if the EBD system fails, the conventional braking system will still function. We have created this dashboard lights meaning guide and will show you how to deal with an engine light, airbag warning light, ABS light and all of the other car warning signs on your Subaru dashboard. If the light illuminates while driving, immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off. Uncategorized. I PULLED FUSE SO THEY WOULD GO OFF'I DO HAVE TURN SINALS-AND BRAKE LIGHTS. Contact your SUBARU dealer immediately for an inspection. However, the rear wheels will be more prone to locking when the brakes are applied harder than usual and the vehicle’s motion may therefore become somewhat harder to control. Tips  It could be a normal indicator light or it could mean a potential issue with your vehicle. If there is no passenger on the front passenger’s seat, the seatbelt warning device for the front passenger’s seat will be deactivated. Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire inflation pressure label. Use of the temporary spare tire should therefore be restricted to the minimum time necessary. Mechanic's Assistant: What confuses you? Show Less. If the electronic parking brake indicator light flashes, the electronic parking brake system may be malfunctioning. The brake system warning light flashes for 20 seconds and a chirp sound will be heard if the parking brake switch is operated too frequently. Got the car towed in again. The electrical system may be malfunctioning. Hoping someone can help me. The icy road surface warning screen should be treated only as a guide. If the tire pressures are not correct and/or the tires are not all the same size and brand, the rear differential will be heavily loaded when the vehicle is driven, resulting in an abnormally high oil temperature. Otherwise, the vehicle may move unexpectedly, causing serious injury or accidents. 3 people found this helpful. Multiple Warning Lights On Dash Subaru Legacy. If the seatbelt warning device for the front passenger’s seat does not function correctly (e.g., it is activated even when the front passenger’s seat is empty or it is deactivated even when the front passenger has not fastened his/her seatbelt), take the following actions: If still the seatbelt warning device for front passenger’s seat does not function correctly after taking relevant corrective actions described above, immediately contact your SUBARU dealer for an inspection. This light also illuminates when the fuel filler cap is not tightened until it clicks. This light illuminates when the cruise control main button is pressed to activate the cruise control function. If the AWD warning light starts to flash, promptly park in a safe place and check whether the tires have differing diameters and whether any of the tires has an excessively low inflation pressure. I only have 1500 miles on my '10 WRX sedan. Outback, Legacy, Forester, Impreza, WRX STI, BRZ, Crosstrek, Tribeca 2013, 2012, 2011, 2010, 2009, 2008. Advanced traction and stability control and other systems are dependent on multiple automotive functions to operate properly. If the light does not turn off, take your vehicle to your authorized SUBARU dealer immediately. Control system becomes unable to provide ABS control. Have your vehicle inspected at a SUBARU dealer as soon as possible. It will turn off when the hill descent control function is not available. Stop the vehicle by depressing the brake pedal when all of the following conditions are met. Thanks Pat If you have a flat tire, replace it with a spare tire as soon as possible. Do not use front seats with their backward-forward position and seatback not being locked into place securely. Multiple warning lights, brake & cruise flashing, check engine & traction control on. Could the salt and damp affected the dashboard wiring? Went to turn head lights on. ** EPA-estimated fuel economy. Failure to do so may prevent the device from functioning correctly or cause the device to fail. This indicator illuminates when the Driver Monitoring System is activated. While driving, this indicator appears and informs the driver about the upshift timing for fuel-efficient driving. The outside temperature indicator shows the temperature in the area around the sensor. In such a case, depress and hold the brake pedal while stopping. Actual mileage will vary. When being towed, turn off the Auto Vehicle Hold function. Blind Spot Detection/Rear Cross Traffic Alert (BSD/RCTA) indicator light. After replacing or adding the engine oil, if the engine oil level is within the normal range when restarting the engine on a level surface, the warning light will turn off. This light illuminates if the brake pedal is not depressed in the following conditions. We recommend that you have your vehicle inspected at a SUBARU authorized dealer as soon as possible. Am on the gulf coast for the first time and car was parked outside by salt water in a rain storm. The brake system warning light flashes when the electronic parking brake system is malfunctioning. Deactivate the Auto Vehicle Hold function in the following cases. If the light does not turn off, contact the nearest SUBARU dealer for service. The warning light illuminates when the electronic control system of the ABS/Vehicle Dynamics Control system malfunctions. The indicator appears when the BSD/ RCTA OFF switch is pressed to deactivate the BSD/RCTA or when the BSD/RCTA is suspended temporarily. If the light illuminates steadily while driving or does not turn off after the engine starts, an emission control system malfunction has been detected. The Driver Monitoring System stops temporarily in the following circumstances. The Vehicle Dynamics Control system is probably inoperative under any of the following conditions. This light illuminates when the automatic headlight beam leveler does not operate normally. Then the Auto Vehicle Hold function will operate. Here are the dashboard warning lights for the Subaru Outback f ourth generation (Mk 4, 2009–2014) and f ifth generation (Mk 5, 2015–2019). Continued vehicle operation without having the emission control system checked and repaired as necessary could cause serious damage, which may not be covered by your vehicle’s warranty. This procedure should be identical fo… ***Limited warranties are contingent on age and mileage. Continuous illumination of the warning light. Did you find a resolution? The Vehicle Dynamics Control system is probably malfunctioning under the following condition. Monthly payment of $15.87 per $1,000 financed. When you release the electronic parking brake while the engine is running, the electronic parking brake indicator light will turn off. dash lights 2 Answers. This indicator light illuminates while the vehicle is stopped by the Auto Vehicle Hold function. The electronic parking brake indicator light flashes when the electronic parking brake system is malfunctioning. This coolant temperature low indicator light/coolant temperature high warning light has the following three functions. Replace the temporary spare tire with a conventional tire as soon as possible. To turn on:  Need to connect with a Hawaiian retailer? Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury. Otherwise, the Auto Vehicle Hold may not operate. The TPMS malfunction indicator is combined with the low tire pressure telltale. If the steering wheel is operated in the following ways, the power steering control system may temporarily limit the power assist in order to prevent the system components, such as the control computer and drive motor, from overheating: At this time, there will be more resistance when steering. Invalid Zip Code. If this light illuminates when the engine is running, it may indicate that the rear differential oil temperature is too hot.